A single object that is composed of line and arc segments
Create Polyline by Tracing
Home tab > Draw panel > Polyline
Pick a first point, tracing the dashed lines.
Stop at the 2nd last point
Command Line: Close
The floor plan is multiple segments but single object
Draw Small Object in Big Drawing
Pick a point beside the floor plan, move cursor down to next point, the distance shown is more than 1000 units.
Zoom-in until the distance show nearest to 30 units
Input 30 and press [Enter]
Command Line: Arc
Input 20 for the radius and press [Enter]
Drag cursor horizontally to right
Input 20 and press [Enter]
Command Line: Line
Pointing cursor up vertically
Input 30 and press [Enter]
Command Line: Close
Width 宽度
Pick a point and drag cursor up vertically
Command Line: Width
Starting width: Input 3 and press [Enter]
Ending width: Press [Enter] to confirm the same width
Input 40 and press [Enter]
Command Line: Width
Starting width: Input 10 and press [Enter]
Ending width: Input 0 and press [Enter]
Pointing cursor up vertically up
Input 25 and press [Enter]
Press [Enter] again to end the command
Arc & Width 圆弧与宽度
Pick a point and pointing cursor up vertically
Input 40 and press [Enter]
Pointing cursor to right horizontally
Command Line: Arc
Command Line: Width
Starting width: Press [Enter] to accept the 0.00 units
Ending width: Input 8 and press [Enter]
drag cursor horizontally
Input 30 and press [Enter]
Command Line: Line
Pointing cursor down vertically
Input 40 and press [Enter]
Press [Enter] to end the command
Polyline Edit 编辑多段线
Open 打开
Double-click on polyline
Click Open
Press [Enter] to confirm
Join 合并
Draw a line to join the opening
Double-click on polyline
Click Join
Cross-select the polyline and line objects
Press [Enter]
Line and polyline join into a polyline
Width 宽度
Double-click on polyline
Click Width
Input 3 and press [Enter]
Press [Enter] again to confirm
Converting Polyline to Line 多段线转换成直线
Select polyline
Home tab > Modify panel > Explode 分解
Polyline convert to lines & arcs
No comments:
Post a Comment